Fix: No Internet access after setting up Linksys Extender

Fix: No Internet access after setting up Linksys Extender

Despite being connected to WiFi, your device lacks internet access. There could be a number of causes for this problem. This issue may be caused by the router's or your software's settings. The reason, though, might only sometimes be obvious.

Here are some tried methods to assist you in fixing the "No Internet Access After setting up Linksys Extender”. Let's go over each one individually.

Basic Fix

To begin, you should determine whether the issue is with your laptop, router, or extender. Connect a tool, such as a smartphone, to WiFi and see if it works. If all of your devices experience the same disconnection issue when connecting to WiFi, the problem is most likely with your electronic equipment, wireless router, or ISP. If, on the other hand, the internet is working correctly on different devices, the problem is with your laptop's WiFi adapter or wifi extender.

Follow these troubleshooting strategies as soon as you identify the source of the problem to resolve the 'No Internet Access After setting up Linksys Extender.

Restart/reboot the wifi extender and router.

If there are any software or hardware issues in the extender that can also cause” Linksys extender connected but no internet issue”.To prevent this from happening, reboot your wifi router and extender devices. Turn them off and leave them like this for about 30 seconds. After 30 seconds, restart them and check whether or not the internet is working.

Examine the credentials you're using.

Your extender can only connect to your wireless router's internet connection if the password you're using is correct. You will only be able to connect to the internet if you enter the correct password. To connect to the extender network, ensure you use a valid password.

Examine the extender’s location

The lack of internet connectivity could have been caused by placing your Linksys extender too far from the reach of your router. To fix the problem,” No Internet Access After setting up Linksys Extender ” move the extender closer to your router and enable communication between the two devices. Also, when relocating your extender, ensure that it is far away from anything that causes WiFi interference and appliances emitting radio waves.

Ensure your router has enabled MAC filters

If the MAC filters on your main router are enabled. To connect to the internet extender needs special permission. By logging into the router setup wizard, you must add the extender's MAC address to the list of Allowed MAC addresses. After that, reconnect to the internet. If you still have trouble connecting to the internet, turn off the MAC filter and reconnect to the network.

Reset your extender

If you're still experiencing issues, try resetting your Linksys extender. If you have completed the Linksys extender setup, follow these steps to reset your extender:

• Hold down the Reset button on your extender.
• Allow the LED light on your extender to shine.
• After that, the extender will restart itself, so you'll have to wait a few minutes.

To restore the default configuration on your WiFi extender, use the web-based button on the Linksys extender login page. However, keep in mind that resetting will erase all of your pre-installed settings. Make a backup of your extender setup.

That concludes the discussion of how to resolve the "No internet access after setting up Linksys extender".